I am using the following configuration and setup. All readings start to drift significantly around 80 C to 125 C. Any idea why is that?

i bought for my private study a launchxl-f28379D and launchxl-f280049C , i've never had an experience with that mcu's before . I'm using a CCS version 12.6.0.00008 on Win11 . I had a problem with ...

Output of TPS63001DRCR is going to connect with Vin of LP3874EMP-ADJ/NOPB and TLV70230QDSERQ1. Do i need to use PTC fuse or other current protection? if i directly connect Vout with Vin of ...

I need help about data rate time for Turbo Mode, Data Rate (011: 350 SPS), Continuous Mode. I will share the code below. (ADS1220_default_regs:0x01, 0x74, 0xC0, 0x00) I connected potentiometer to the ...

I need to design a variable step down regulator using TPS54560BQDDARQ1. The adjustment is done using a DAC and 3 resistors in a such a way output voltage goes from 1V to 30V with an input control ...

・Target range of secondary side output voltage is approximately ±5V to ±10V. I found ISO224, but please let me know if there is anything else. 2)Which product has the same or higher specs as the ...

I am working on a project using the Xilinx (AMD) ZCU216 development kit with the CLK104 add-on card. The CLK104 board uses the LMK04828. I am providing a 10MHz reference signal to the LMK chip using ...

0x60 = 0 1 1 0 0 0 0 0 ---> Power-down internal reference buffer + 4v vref + Noninverting input connected to the OPAMPP pin + Power-down op amp After the configuration of all configuration registers, ...